The special application of film sticking machine is analyzed

The film sticking machine manufacturers have analyzed the special application of the film sticking machine. With the improvement of the production process and the quickening of the production process, the processing scope of the film sticking machine has broken through the traditional single riveting field, expanded to riveting, sealing, point pressure and other more and more new categories, as a new processing method. In the processing field of electric fan Shell and lock Shell, riveting parts often exist in the shell. This kind of parts with five-end sealing and one-end opening, using traditional manual riveting method processing appears very clumsy, but the general equipment is also in a loss. However, for the machine, this part of the processing is very simple, only need to spend tens of dollars to do a special-shaped riveting joint, through the machine’s pure rotation forging movement to complete riveting. Because the special-shaped Rivet can not rotate along the axial direction in the pure rotary forging, the interference between the rivet and the shell-shaped parts need not be worried. The process takes only a few seconds and is quick and easy. Such as sensors, spark plugs, automotive steering pins, shock absorbers and other parts that need to be sealed, people often use presses or lathes to complete the processing of sealing. But actually, the sealing process of the film sticking machine has a great advantage over the sealing process of the film sticking machine. The sealing pressure and sealing degree can be controlled arbitrarily, and even the deformation of weak pressure and point-by-point rolling can overcome the problems of internal stress and crack, one of the most important is that the surface quality and airtightness of the sealing parts processed by film pasting machine is not inferior to any other traditional processing methods.Riveting can be done in a variety of shapes, the most common being round, triangular, square, or irregular. These restrictions are mainly due to the special requirements of riveted parts, such as riveted square steel flanging plates. If using other processing methods, such parts processing is very complex, quality can not be guaranteed, must use the film sticking machine. In many hydraulic parts and components, process holes or oil holes are usually sealed with steel balls. Some of these seals need to move, such as oil hole, Oil Cup, steel ball can be pressed in can also be repaired; some like process hole need steel ball fixed seal oil, no oil leakage, no oil leakage. The processing of these parts is sticking film machine, as long as the machine is adjusted, ball head pre-pressing, stamping, riveting edge can be completed once, high efficiency, good quality.